Lie-Nielsen Toolworks #60-1/2 Low Angle Adjustable Mouth Block Plane
Based on the Stanley #60-½, this versatile plane is useful for every sort of woodworking job and a pleasure to use.
The moveable shoe in front of the blade allows you to easily and precisely adjust the mouth opening: fine mouth for finishing work and thin shavings, or ample opening for rank cuts.
The Ductile Iron body is surface ground flat and square to a tolerance of .001" or better. The large, comfortable Bronze cap is tensioned with a 1-1/2" Brass spinwheel. Like our other block planes, the blade is adjusted with a captive nut for precise control with minimal backlash.
The blade is bedded at 12º for fine cuts and end grain. Weight 1.5 lbs.
- 6-1/4" long
- 1-3/4" wide
- Blade is 1-3/8" wide x 1/8" thick.
- The blade is bedded at 12º
- Weight 1.5 lbs.
The No. 60-1/2 rated
"BEST OVERALL BLOCK PLANE"
- Fine Woodworking Tool Guide
(2009, 2010, 2012, 2013, 2014)
Adjustable Mouth Block Planes:
The Adjustable Mouth Block Plane is a general purpose tool, useful for fine trimming and finishing work, as well as rapid stock removal. The body has an adjustable shoe to allow quick and easy control of the mouth opening. The best finishes will be obtained with the blade set to take a very small cut, and with the mouth opening no larger than necessary to pass the chip. When you want to cut more aggressively, open the mouth more and advance the blade for deeper cut. For best results on end grain, set the blade and mouth fine.
In the Low Angle Plane, the blade is bedded at 12°, making the included cutting angle 37°.
The blade comes ready to use. Slight additional honing will increase performance. A secondary bevel of up to 5 degrees helps achieve a razor edge quickly. This also improves edge life in hardwoods. For more information on advanced sharpening we suggest David Charlesworth’s DVD Hand Tool Techniques Part 1: Plane Sharpening.
Hold the sole in the palm of your hand and loosen the brass locking screw. Adjust with the brass lever. Tighten the screw firmly, but do not overtighten.
Hold the tool in one hand with your fingers supporting the sole and your thumb on the cap iron just in front of the screw. Loosen the spinwheel and, with your thumb still holding the blade and cap, adjust the blade. Tighten the spinwheel. Do not overtighten. You should be able to adjust the blade after loosening the spinwheel about ¼ turn. Make sure the mouth is adequately open before advancing the blade to avoid damaging the edge.
We Also Recommend
Lie-Nielsen Toolworks #51 Shooting Board Plane, Right Hand Version
Lie-Nielsen Toolworks #073 Large Shoulder Plane
Lie-Nielsen Toolworks #140B-R, Skew Block Plane R/Hand
Lie-Nielsen Toolworks #62 Jack Plane, Low Angle